This is a working overview of Tetrapeptide, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C14H22N4O9 | Free acid form of the tetrapeptide |
| Molecular mass | About 390.35 Da | Calculated monoisotopic value |
| Appearance | White to off-white powder | Typical lyophilized presentation |
| Solubility | Soluble in water | Also dissolves in buffered saline |
| Storage temperature | Minus 20 degrees Celsius | Dry, dark conditions; avoid repeated thawing |
Chemically, the molecule consists of four amino acid residues joined by three peptide bonds, with a free N-terminal amino group and a free C-terminal carboxyl group. Its molecular formula is C14H22N4O9, and its monoisotopic mass is approximately 390 daltons. The acidic glutamate and aspartate side chains give the peptide a net negative charge near neutral pH, a property that shapes its chromatographic behaviour and solubility profile. No disulfide bridges or other post-translational modifications are present, so the primary sequence alone defines the structure.
Most experimental work has been carried out in cell culture and animal models. Several reports describe changes in telomerase activity and proliferation in cultured cells, while rodent studies have examined lifespan, melatonin rhythm and reproductive endpoints. Human data remain limited, and much of the published clinical material consists of small trials with incomplete reporting of methods and controls. Whether the cell and animal findings translate into measurable effects in people is an open question, and the mechanistic basis of the reported telomerase changes is not fully established.
Discussions in the literature often conflate three distinct entities: the pineal extract epithalamin, the isolated tetrapeptide AEDG, and commercial preparations sold under similar names. Reviews citing older Russian-language studies sometimes omit detail on purity, route of administration and control groups, which makes cross-study comparison difficult. Researchers working with the compound generally note the need for independent replication, standardized enzyme assays, and clearer reporting of peptide identity. These caveats are relevant when weighing claims that appear in secondary sources rather than in primary reports.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Published studies on epitalon are dominated by a small number of research groups, and independent replication in other laboratories remains limited. Proposed mechanisms include activation of telomerase and modulation of melatonin rhythms, but the evidence for either rests mainly on cell cultures and animal models. Whether the peptide produces comparable effects in humans is an open question, and the absence of large controlled trials means the literature is best read as exploratory rather than settled.
Epitalon is a synthetic four-amino-acid peptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9, and its calculated molar mass is approximately 390.35 grams per mole. The compound is a short fragment related to a peptide fraction isolated from bovine pineal gland extracts, and it is normally supplied as a lyophilised powder intended for laboratory research. It is not a registered pharmaceutical product in most countries.
The peptide emerged from research carried out in Saint Petersburg from the late 1980s onward, where investigators searched for shorter active fragments of a pineal preparation known as epithalamin. The name epitalon was chosen to reflect that parent extract. Early reports described effects on neuroendocrine markers and on the lifespan of laboratory animals. Much of that work appeared in Russian-language journals, with English translations following later, which affects how readily the original protocols can be assessed by outside groups.
The structures of acceptors play a critical role in the rate and stereoselectivity of glycosylations. Generally, the unprotected hydroxyl groups are less reactive when they are between bulky protecting groups. That is the reason why the hydroxyl group at OH-4 in pyranosides is unreactive. Hyperconjugation is involved when OH-4 is anti-periplanar to the ring oxygen, which can also reduce its reactivity. (Scheme 3) Furthermore, acyl protecting groups can reduce the reactivity of the acceptors compared with alkyl protecting groups because of their electron-withdrawing ability. Hydroxyl group at OH-4 of N-acetylglucosamine derivatives is particularly unreactive.
The fissile properties of uranium-233 were established at the University of California, Berkeley during 1941 and early 1942 by Glenn T. Seaborg, John W. Gofman and Raymond W. Stoughton, who showed that the isotope undergoes fission with slow neutrons and was therefore a potential nuclear fuel. Their report was mailed to the Uranium Committee in Washington on 14 April 1942, but wartime secrecy kept the work from open publication until 1947, when an abridged version appeared in Physical Review. In 1946, the public first became informed of uranium-233 bred from thorium as "a third available source of nuclear energy and atom bombs" (in addition to uranium-235 and plutonium-239), following a United Nations report and a speech by Glenn T. Seaborg. The United States produced, over the course of the Cold War, approximately 2 metric tons of uranium-233, in varying levels of chemical and isotopic purity. These were produced at the Hanford Site and Savannah River Site in reactors that were designed for the production of plutonium-239.
===== Sweden ===== Cannabidiol is classified as a medical product in Sweden. However, in July 2019, Supreme Court of Sweden ruled that CBD oil with any concentration of THC falls under the narcotic control laws.
Sources: en.wikipedia.org
== Clinical significance == Mutations in SPINK1 has been associated with hereditary pancreatitis and tropical pancreatitis. Trypsinogen is normally created and stored an inactive zymogen of trypsin in the pancreas, but occasionally will autoactivate itself. PSTI serves to cleave prematurely activated trypsin to prevent the enzyme from causing cellular damage to the organ. Without the function of PSTI, the pancreas is subject to repeated episodes of damage. It has also been associated with prostate cancer.
The occasion was marked by widespread public attention and official greetings, including from Prime Minister Anwar Ibrahim and other members of his unity government. Former Singapore Prime Minister Lee Hsien Loong also extended his birthday wishes to Mahathir.
== Nucleotide excision repair == As illustrated above, (+)-benzo[a]pyrene-7,8-dihydrodiol-9,10-epoxide (BPDE) forms bulky covalent DNA adducts with guanines. Most of these adducts can be efficiently eliminated from DNA by the process of nucleotide excision repair. Those adducts that are not removed can cause errors during DNA replication leading to carcinogenic mutations.
Sources: en.wikipedia.org
Epitalon is a synthetic tetrapeptide built from four amino acids: alanine, glutamate, aspartate, and glycine. It is not extracted from a natural source but made in the laboratory by chemical synthesis. Its short length makes it relatively straightforward to produce at high purity.
No naturally occurring free form of the peptide has been described. The four-amino-acid sequence can appear as a fragment within larger proteins, but that is not the same as the intact compound being present as a circulating molecule. Materials used in research are synthetic.
Purity is usually checked by reverse-phase high-performance liquid chromatography, which separates the target peptide from related impurities. Mass spectrometry is commonly used alongside it to confirm molecular mass. Some suppliers also provide amino acid analysis for additional sequence confirmation.
Mass spectrometry provides the identity check, because the observed mass is compared with the theoretical mass of the AEDG sequence. Chromatography separates and quantifies impurities but does not by itself prove which peptide is present. The two techniques are normally used together.