The short version of mass spectrometry fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-01-19 and is reviewed periodically as new material appears.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Because epitalon has no pharmacopoeial monograph, quality assessment depends on supplier documentation and independent testing. Certificates of analysis typically report a purity figure from a single chromatographic run, a measured mass and sometimes an appearance description, but methods and acceptance criteria are not harmonised across vendors. Third-party laboratories can repeat identity and purity measurements, and mismatches between labelled and measured peptide content have been described for research peptides generally. What constitutes adequate identity confirmation for a molecule of this size stays an open question, since mass agreement alone does not separate closely related sequences.
Identity testing for epitalon relies on reversed-phase high-performance liquid chromatography for purity and mass spectrometry for mass confirmation. Because the sequence contains no tryptophan or tyrosine, ultraviolet detection at 280 nanometres is insensitive, so chromatographic methods usually monitor absorbance near 214 nanometres, where the peptide backbone absorbs. Electrospray ionisation or matrix-assisted laser desorption/ionisation then checks the intact mass against the expected value near 390 daltons. Peptide mapping or amino acid analysis after acid hydrolysis can supplement these measurements, although such confirmatory work is seldom reported on commercial certificates of analysis.
| Property | Value | Notes |
|---|---|---|
| Amino acid sequence | Ala-Glu-Asp-Gly | Linear tetrapeptide, also written AEDG |
| Molecular mass | About 390.35 g/mol | Value calculated from the sequence |
| Appearance | White to off-white powder | Lyophilised material forms a loose cake |
| Solubility | Freely soluble in water | Also dissolves in isotonic saline |
| Storage | -20 °C, desiccated | Aliquot solutions to avoid freeze–thaw cycling |
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
In its supplied form epitalon is a white to off-white powder, usually lyophilized and often hygroscopic. It dissolves readily in water and in aqueous buffers, and it is commonly handled as the acetate or trifluoroacetate salt to improve stability during purification and drying. The amide backbone is labile in aqueous media, so solutions are less durable than the dry solid. Handling notes in the chemical literature therefore emphasize keeping the powder dry, cool and shielded from light until it is dissolved.
Epitalon is a synthetic tetrapeptide whose sequence is alanine-glutamate-aspartate-glycine, written in single-letter code as AEDG. The four residues are joined by three peptide bonds, giving a linear backbone with no branching and no disulfide bridges. Its calculated molecular mass for the free form is approximately 390.3 daltons, a figure that rises when the compound is supplied as an acetate or trifluoroacetate salt. Because the chain is short, the molecule is defined entirely by its residue order rather than by any folded three-dimensional structure.
Short peptides such as AEDG are normally supplied as a freeze-dried solid and are kept dry, cold, and shielded from light. Holding at minus twenty degrees Celsius is common for the long term, while a refrigerator suffices for brief periods before use. The material takes up moisture to some degree, so containers should stay sealed and be allowed to reach room temperature before opening, which limits condensation on the contents. Repeated warming and cooling of a single container is discouraged because it admits water and can lower the amount of intact peptide.
Dissolution is usually performed in water or a suitable aqueous buffer, and the resulting liquid is divided into single-use portions before freezing. Freeze-thaw cycling is a recognised source of loss for short peptides, since each cycle can encourage aggregation or adsorption onto container walls. Working solutions are generally kept cold and used within a short window, although published stability data specific to epitalon are thin. Containers should be marked with concentration and date, and solutions examined for cloudiness before use.
The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.
Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.
Epitalon is a synthetic tetrapeptide whose four residues are alanine, glutamate, aspartate and glycine, commonly abbreviated AEDG. Its molecular formula is C14H22N4O9 and its monoisotopic mass is near 390.35 daltons. The peptide carries two acidic side chains, so it is neutral to negatively charged in most aqueous buffers. Published reference summaries usually list it under both spellings, epitalon and epithalon, and treat the two names as the same material.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
Identity confirmation uses mass spectrometry, usually electrospray ionisation in positive mode or matrix-assisted laser desorption. The protonated free peptide produces a signal near three hundred and ninety-one daltons, while salt adducts shift that value slightly. Tandem mass spectrometry or amino acid analysis supplies sequence-level confirmation, which a single mass measurement cannot. Peptides containing aspartate can cyclise into succinimide intermediates that hydrolyse to isoaspartate isomers of identical mass. Because those isomers are difficult to separate chromatographically, identity and purity results carry more weight when interpreted together.
An Alu polymorphism analysis by Mastana S (2007) using Sinhalese, Tamil, Bengali, Gujarati (Patel), and Punjabi as parental populations found the following proportions of genetic contribution. The Sinhalese sample size used was 121 individuals.:
== Products == Its primary products are based on Morpholino oligomers (PMOs), synthetic nucleic acid analogs that were conceived of by James Summerton and invented by Summerton with Dwight Weller, originally developed under the name NeuGene Antisense. Since morpholino oligomers can form sequence-specific double-stranded complexes with RNA they are suitable use in antisense therapy. In one application, translation blocking, a morpholino oligomer binds to messenger RNA produced by a known disease-causing gene to prevent it from being translated into protein. Morpholinos can also work as splice-switching oligos, targeting pre-mRNA to alter splicing and so causing changes in the structure of the mature mRNA (the mechanism of the approved drug eteplirsen). Morpholinos have been tested for a wide range of applications including prevention of cardiac restenosis after angioplasty, treatment of coronary artery bypass grafts, treatment of polycystic kidney disease, redirection of drug metabolism, treatment of some mutations causing Duchenne muscular dystrophy (DMD), and inhibition of infectious diseases. Their greatest clinical and commercial success thus far has been in the treatment of DMD. A new class of Morpholino oligos, the peptide-linked Morpholinos or PPMO, are linked to an arginine-rich cell-penetrating peptide to enhance their delivery into cells and have entered clinical trials.
hypotonic Describing a solution containing a low concentration of dissolved solutes relative to another solution, i.e. having negative osmotic pressure, such that solvent will tend to move by osmosis across a semipermeable membrane from the solution of lower solute concentration to the solution of higher concentration until both solutions have equal concentrations. In a cell where the intracellular cytosol is hypotonic relative to the surrounding extracellular fluid (which by definition is hypertonic relative to the cytosol), the solvent (water) will flow across the plasma membrane out of the cytosol, causing the cell to lose water until both sides of the membrane are isotonic. Cells placed in severely hypertonic environments may be at risk of shriveling and desiccating due to the sudden outflow.
The Chou–Fasman method is an empirical technique for the prediction of secondary structures in proteins, originally developed in the 1970s by Peter Y. Chou and Gerald D. Fasman. The method is based on analyses of the relative frequencies of each amino acid in alpha helices, beta sheets, and turns based on known protein structures solved with X-ray crystallography. From these frequencies a set of probability parameters were derived for the appearance of each amino acid in each secondary structure type, and these parameters are used to predict the probability that a given sequence of amino acids would form a helix, a beta strand, or a turn in a protein. The method is at most about 50–60% accurate in identifying correct secondary structures, which is significantly less accurate than the modern machine learning–based techniques.
Measured Kovats retention index values can be found in ASTM method D 6730 databases. An extensive Kovats index database is compiled by NIST [1]. The equations produce significant different Kovats indices.
Sources: en.wikipedia.org
=== Antigen discrimination === A unique feature of T cells is their ability to discriminate between healthy and abnormal (e.g. infected or cancerous) cells in the body. Healthy cells typically express a large number of self derived pMHC on their cell surface and although the T cell antigen receptor can interact with at least a subset of these self pMHC, the T cell generally ignores these healthy cells. However, when these very same cells contain even minute quantities of pathogen derived pMHC, T cells are able to become activated and initiate immune responses. The ability of T cells to ignore healthy cells but respond when these same cells contain pathogen (or cancer) derived pMHC is known as antigen discrimination. The molecular mechanisms that underlie this process are controversial.
Casualty numbers have escalated significantly over time. According to a Stratfor report, the number of drug-related deaths in 2006 and 2007 (2,119 and 2,275) more than doubled to 5,207 in 2008. The number further increased substantially over the next two years, from 6,598 in 2009 to over 11,000 in 2010. According to data from the Mexican government, the death numbers are even higher: 9,616 in 2009, 15,273 in 2010, coming to a total of 47,515 killings between 2006 and January 2012. It is often not clear what deaths are part of the Mexican drug war versus general criminal homicides, and different sources give different estimates. Casualties are often measured indirectly by estimated total deaths from organized crime in Mexico. This amounts to about 115,000 people in the years 2007–2018. From 2018 to 2020, it was estimated that there were 11,400 reports of gang violence, and over 80% of the attacks targeted civilians, resulting in 13,000 related deaths during the period.
=== Nuclear magnetic resonance spectroscopy === Metal carbonyls are often characterized by 13C NMR spectroscopy. To improve the sensitivity of this technique, complexes are often enriched with 13CO. Typical chemical shift range for terminally bound ligands is 150 to 220 ppm. Bridging ligands resonate between 230 and 280 ppm. The 13C signals shift toward higher fields with an increasing atomic number of the central metal. NMR spectroscopy can be used for experimental determination of the fluxionality. The activation energy of ligand exchange processes can be determined by the temperature dependence of the line broadening.
== Interactions == There are a few types of medications that interact with valsartan. Combined use with nonsteroidal anti-inflammatory drugs (NSAID) such as naproxen or ibuprofen can result in kidney injury in people who are elderly, dehydrated, or have reduced kidney function. One study conducted Lapi F., et al. found that there was no increased risk of kidney injury when only using either a diuretic or angiotensin receptor blocker with an NSAID but did find an increased risk when all three medications were used together. Valsartan usage with angiotensin receptor blocker, ACE inhibitors, or aliskiren results in additive side effects.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide. Its sequence was derived from research on peptide fractions of bovine pineal extract, and the intact AEDG sequence has not been demonstrated as an abundant free peptide in human tissue.
AEDG is the one-letter code for the four amino acids alanine, glutamate, aspartate and glycine in that order. The same molecule is written in three-letter form as Ala-Glu-Asp-Gly.
Identity is normally confirmed by mass spectrometry against the calculated mass of roughly 390.35 g/mol. Purity is then estimated by reversed-phase high-performance liquid chromatography with ultraviolet detection.
The molecule lacks aromatic residues, so it absorbs weakly near 280 nanometres, the wavelength applied to many other peptides. The peptide bond absorbs strongly below 220 nanometres, making 214 nanometres a practical compromise. Gradient methods must therefore use mobile phases with low ultraviolet absorbance to keep the baseline clean.